Gottlieb System-80 Pinball Repair Service Pop Bumper Driver

Here's a table of rates for each type of repair, and all prices include parts and labor. If I can't fix it, you don't pay!

I also ask that you pay return postage, which will be the going rate for U.S. Priority mail, or International Priority mail, plus optional insurance.

Complete rebuild New parts all around, and upgraded as described here.	$15.00
Connector Kit New housing, key, and plenty of trifurcon crimp-on pins.	$2.00

Prices above do not include return shipping

So feel free to send me your pop bumper driver boards and I'll take a look and let you know what I think, then you can decide what to do from there. Probably a good idea if you e-mail me first, just so I know what to expect (remove the NO_S*P*A*M_).

If I can't fix it, you don't pay, except for return postage.

Here's a picture of one that I recently rebuilt - new parts all around:

Here's another one, before and after. This one is the older design that really needs to be upgraded as they don't work worth a crap when they're like the one on the left. Notice on the old version, there are two small diodes instead of one, no jumper wire, and the axial capacitor's positive end points towards the edge of the board:

Of course, there's always Ts & Cs (revised), and don't forget prices DO NOT include shipping.

If you decide to "do it yourself", visit Big Daddy or GPE for all the parts you'll need.
I'll still fix it when you're done. :-)

Thanks!